Post
Zenless Zone Zero: Damage Setup Guide for Beginners (Critical Hit Rate and Damage Calculation)
This video is a beginner's guide on how to set up for better damage in Zenless Zone Zero, specifically calculating and adjusting the crit rate and crit damage ratio. The key is to help understand the importance of substats and the efficiency of flat ATK.
1. How to Calculate Crit Rate and Damage Ratio
The ideal ratio of crit rate (CR) to crit damage (CD) is 1:2.
When calculating, you should use the final CR and CD values considering all buffs.
The formula is 'CR x CD', and the setup with the higher value is more advantageous.
00:05 - 01:25
1. How to Calculate Crit Rate and Damage Ratio
The ideal ratio of crit rate (CR) to crit damage (CD) is 1:2.
When calculating, you should use the final CR and CD values considering all buffs.
The formula is 'CR x CD', and the setup with the higher value is more advantageous.
01:26 - 02:46
2. Actual Damage Calculation Example and Additional Considerations
You need to consider the increase in crit damage due to the MB character's exclusive engine and additional abilities.
If crit damage increases in the Disk setup, you need to include all of this in the calculation for an accurate comparison.
02:47 - 03:36
3. Importance and Priority of Substats
Setups with more substats are generally better, even if the ratio is slightly lower.
A difference of one substat can make a difference of about 1-2% in damage.
The priority for setup is the number of substats > crit ratio.
03:37 - 04:40
4. Flat ATK Efficiency
3 flat ATK stats have similar efficiency to 1 ATK% stat.
The more flat ATK you have, the more you may lose out on other substats, so it's not an efficient choice.
You can understand that if flat ATK is attached, there is a difference in the number of substats.
04:41 - 05:04
5. Summary of Considerations When Setting Up
When setting up, it is important to calculate the final damage by considering the number of substats and the crit ratio.
Flat ATK is less efficient, but if it is attached as a substat, you should consider this when deciding on your setup.